214603 22 Revision A
Figure 1.35: MD #166457
MD #166457
General hazard pertaining to machine operation and
servicing
CAUTION
To avoid injury or death from improper or unsafe machine
operation:
• Read the operator’s manual and follow all safety
instructions. If you do not have a manual, obtain one
from your Dealer.
• Do not allow untrained persons to operate the machine.
• Review safety instructions with all Operators every year.
• Ensure that all safety signs are installed and legible.
• Make certain everyone is clear of machine before
starting engine and during operation.
• Keep riders off the machine.
• Keep all shields in place and stay clear of moving parts.
• Disengage header drive, put transmission in Neutral and
wait for all movement to stop before leaving operator’s
position.
• Stop the engine and remove the key from the ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging machine.
• Engage locks to prevent lowering of header or reel
before servicing in the raised position.
• Use slow moving vehicle emblem and flashing warning
lights when operating on roadways unless prohibited
by law.
Run-over hazard
WARNING
• Machine will move if steering wheel is turned while
engine is running.
• Steering response is opposite to what is normally
expected when backing up. Turn bottom of steering
wheel in direction you want to go.
• Always move ground speed lever to slow end of range
before shifting high-low speed control.
• Stop the engine and remove the key from the ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging the machine.
SAFETY
To Next Page
Loading...
