MacDon M205 - Page 437

214603 417 Revision A
Action: üü Check SS Lubricate ▲ Change ®® Clean
heater/hydraulic
36
. Refer to specific hose clamp section.
ü
Walking beam width adjustment bolts
Refer to 4.3.7 Adjusting Caster Tread Width, page 177.
ü
Caster wheel anti-shimmy dampener
bolts (if installed). Refer to Tightening Caster Wheel Anti-Shimmy Dampeners, page 413.
p
Main gearbox oil
Refer to Changing Lubricant, page 344.
p
Drive wheel lubricant
Refer to Changing Wheel Drive Lubricant, page 402.
p
Charge system oil filter (if applicable)
Refer to Charge Oil Filter, page 387.
p
Return oil filter
Refer to Return Oil Filter, page 389.
Every 50 hours
33
®
Cab fresh air intake filter
Refer to Inspecting and Cleaning Fresh Air Filter Element, page 304.
S
Caster pivots
Refer to 5.4.2 Lubrication Points, page 294.
S
Forked caster spindle bearings
Refer to 5.4.2 Lubrication Points, page 294.
ü
Gearbox oil level
Refer to Checking Lubricant Level and Adding Lubricant, page 343.
S
Top lift link pivots
Refer to 5.4.2 Lubrication Points, page 294.
S
Walking beam center pivot
37
Once a year
38 39
ü
A/C blower
Refer to Air Conditioning (A/C) Compressor Coolant Cycling, page 163.
ü
Antifreeze concentration
Refer to Checking Engine Coolant Strength, page 332.
MAINTENANCE AND SERVICING
36. Hand-tighten unless otherwise noted.
37. 2014 and previous.
38. Begins from first use of machine.
39. It is recommended that annual maintenance be done prior to start of operating season.