MacDon M205 - Page 442

214603 422 Revision A
Symptom
Problem
Solution Reference
Engine hard to
start or will
not start
Wiring shorted, circuit
breaker open
Check continuity of wiring and breaker
(manual reset).
Checking and
Replacing Fuses,
page 379
Engine hard to
start or will
not start
ECM fuse (1 of 2) blown
Replace.
Checking and
Replacing Fuses,
page 379
Engine hard to
start or will
not start
ECM Ignition relay faulty
Replace.
Checking and
Replacing Fuses,
page 379
Engine hard to
start or will
not start
NEUTRAL Logic relay faulty
Replace.
Checking and
Replacing Fuses,
page 379
Engine hard to
start or will
not start
Faulty injectors
Contact Dealer. Contact Dealer
Engine knocks
Engine out of time Contact Dealer. Contact Dealer
Engine knocks
Insufficient oil
Add oil.
Adding Engine Oil,
page 316
Engine knocks
Low or high coolant
temperature
Contact Dealer. Contact Dealer
Engine knocks
Improper fuel Use proper fuel.
8.2.2 Fuel
Specifications,
page 460
Low oil pressure Low oil level Add oil.
Adding Engine Oil,
page 316
Low oil pressure
Improper type of oil
Drain and fill crankcase with
proper oil.
8.2.3 Lubricants,
Fluids, and System
Capacities, page
461
Low oil pressure Worn components
Contact Dealer. Contact Dealer
High oil
consumption
Internal parts worn
Contact Dealer. Contact Dealer.
High oil
consumption
Crankcase oil too light
Use recommended oil.
8.2.3 Lubricants,
Fluids, and System
Capacities, page
461
High oil
consumption
Oil leaks
Check for leaks around gaskets,
seals, and drain plugs.
Checking Engine
Oil Level, page
313
Engine runs
irregularly or stalls
frequently
Unsteady fuel supply
Change filter on fuel tank vent line.
Replace clogged fuel filter.
Replacing Fuel
Tank Vent Filter,
page 323 and
5.8.5 Fuel System,
page 323
TROUBLESHOOTING