Networking (AMIS)
240 ◆ Chapter 2: Features UX Mail Manual
Step 3 Enter the access digits for network callouts.
3.1 FOR LOCAL NETWORK CALLOUTS, SEE CUSTOMIZE: TENANT OPTIONS: [ACCESS DIGITS] NETWORK LOCAL
CALLOUT (PAGE 481).
3.2 FOR LONG DISTANCE NETWORK CALLOUTS, SEE CUSTOMIZE: TENANT OPTIONS: [ACCESS DIGITS] BEFORE NET-
WORK LONG DISTANCE CALLOUT (PAGE 482).
- A typical entry for either option is 9P, where:
9 is the trunk access code.
P is a pause.
- If long distance calls require a leading 1, add it to the access digits (e.g.,
9P1).
✔ By default, there are no entries for these options.
Step 4 To use a Network Remote Mailbox for recording and sending network messages:
4.1 WHEN RECORDING AND SENDING A NETWORK MESSAGE, THE EXTENSION USER MUST DIAL THE NETWORK MAIL-
BOX NUMBER PLUS THE MAILBOX NUMBER IN THE REMOTE SYSTEM.
- If networking with multiple remote systems, you could set up a Network Remote Mailbox
for each system.
4.2 CUSTOMIZE: MAILBOX OPTIONS EDIT: [GENERAL] MAILBOX TYPE (PAGE 405).
- Select Network to enable a Network Mailbox.
✔ By default, there are no Network Mailboxes programmed.
4.3 CUSTOMIZE: MAILBOX OPTIONS EDIT: [NETWORK] TYPE (PAGE 412).
- Select Remote to set up the mailbox as a Network Remote Mailbox.
✔ By default, this option is
Alias (Network Alias Mailbox).
Step 5 To use a Network Alias Mailbox for recording and sending network messages:
5.1 WHEN RECORDING AND SENDING A NETWORK MESSAGE, THE EXTENSION USER JUST DIALS THE NETWORK MAIL-
BOX NUMBER TO LEAVE A MESSAGE AT A SPECIFIC MAILBOX IN THE REMOTE SYSTEM. THEY DON’T HAVE TO
ADDITIONALLY ENTER A REMOTE SYSTEM MAILBOX NUMBER.
5.2 CUSTOMIZE: MAILBOX OPTIONS EDIT: [GENERAL] MAILBOX TYPE (PAGE 405).
- Select Network to enable a Network Mailbox.
✔ By default, there are no Network Mailboxes programmed.
5.3 CUSTOMIZE: MAILBOX OPTIONS EDIT: [NETWORK] TYPE (PAGE 412).
- Select Alias to set up the mailbox as a Network Alias Mailbox.
✔ By default, this option is
Alias (Network Alias Mailbox).
5.4 CUSTOMIZE: MAILBOX OPTIONS EDIT: [NETWORK] NETWORK MAILBOX (PAGE 412).
- Enter the number of the mailbox in the remote system the should receive the message when
a user records and sends a message for this network mailbox.
- For example, if the Network Alias Mailbox should automatically leave a message in
remote system mailbox 310, enter 310.
✔ By default, there is no entry for this option.
Step 6 Enter the number of the Automated Attendant in the remote system.
6.1 CUSTOMIZE: MAILBOX OPTIONS EDIT: [NETWORK] NETWORK CALL TYPE (PAGE 413).
-
This is the call type used by the Network Mailbox when delivering messages to the
remote system.
- If it is a long distance call to remote system, select Long Dis.
- When the system delivers a network message, the long distance number is preceded
by the entry you made in Customize: Tenant Options:
[ACCESS DIGITS] BEFORE NET-
WORK LONG DISTANCE CALLOUT (PAGE 482).
- If it is a local number to the remote system
, select Local.
- When the system delivers a network message, the local number is preceded by the
entry you made in Customize: Tenant Options:
[ACCESS DIGITS] NETWORK LOCAL CALL-
OUT (PAGE 481).
- If you don’t want the remote callout number preceded by access digits
, select Internal.
To Next Page
Loading...
