NEC UX5000 - Page 271

Park and Page
UX Mail Manual Chapter 2: Features ◆ 253
2
Operation
Park and Page
(With Automated Attendant Screened Transfers)
When the subscriber’s Paging Message is recorded and turned on:
1.
After the Automated Attendant answers, dial the subscriber’s extension number.
2. Voice mail parks the call at the subscriber’s extension and pages them with the Paging Message.
■ The call will remain parked for the UX5000 Park Recall time.
3. To pick up the call:
- Subscriber presses idle
CALL key + ** + Their extension number.
If the subscriber does not pick up the call, you can dial
:
- 1 to leave a message in the subscriber’s mailbox.
- 2 to page again.
- 3 for other options (depending on the Next Call Routing Mailbox setting for the called subscriber’s mailbox).
When the subscriber’s Paging Message is recorded and turned off:
1.
After the Automated Attendant answers, dial the subscriber’s extension number.
■ If the subscriber’s extension is busy, Park and Page does not occur. You are asked to leave a message in the called exten-
sion’s mailbox instead.
2. Voice mail tries (rings) the subscriber’s extension. If unanswered, you can dial:
- 1 to leave a message in the subscriber’s mailbox.
- 2 to page again.
- 3 for other options (depending on the Next Call Routing Mailbox setting for the called subscriber’s mailbox).
Park and Page
(With Automated Attendant Unscreened Transfers and Directory Dialing)
When the subscriber’s Paging Message is recorded and turned on or off:
1.
After the Automated Attendant answers, dial the subscriber’s extension number.
2. If the subscriber’s extension is unanswered or busy, you can dial:
- 1 to leave a message in the subscriber’s mailbox
- 2 to page (i.e., use Park and Page)
- 3 for other options (depending on the Next Call Routing Mailbox setting for the called subscriber’s mailbox).