R&S ZNB - Page 1102

Command Reference
R&S
®
ZNB/ZNBT
1102User Manual 1173.9163.02 ─ 55
MMEMory:STORe:TRACe:OPTion:SSEParator <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, separator lines are skipped, i.e. the content parts are no longer separated
by blank lines.
Parameters:
<Boolean>
Manual operation: See "Skip Separator Lines" on page 707
MMEMory:STORe:TRACe:OPTion:SYMMetric <Boolean>
This command activates/deactivates the export of symmetric (balanced) S-parameters
for MMEMory:STORe:TRACe:PORTs.
Parameters:
<Boolean>
Manual operation: See "Symmetric Params" on page 337
MMEMory:STORe:TRACe:OPTion:TABS <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, columns are separated by tabs rather than spaces.
Parameters:
<Boolean>
Manual operation: See "Use TAB (instead of blanks)" on page 707
MMEMory:STORe:TRACe:OPTion:TRIM <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, whitespace at the beginning of each line is removed.
Parameters:
<Boolean>
Manual operation: See "Trim Leading Whitespace" on page 707
MMEMory:STORe:TRACe:PORTs <Channel>, <TouchstoneFile>, <Format>[,
<ModeImpedance>, <Port>, <Port>...]
Generates an snp Touchstone file, where n is the number of specified ports.
If MMEMory:STORe:TRACe:OPTion:SYMMetric is OFF, the Touchstone file contains
the full set of single-ended S-parameters. Otherwise it contains the full set of mixed
mode S-parameters. Both sets have a size of n
2
.
SCPI Command Reference