R&S ZNB - Page 1259

Command Reference
R&S
®
ZNB/ZNBT
1259User Manual 1173.9163.02 ─ 55
Suffix:
<Ch>
.
Channel number
<Grp> Port group number
Parameters:
<NumPorts> Number of connected ports
Example: See SOURce<Ch>:GROup<Grp>:PPORt<PhyPort>:DPORt
Manual operation: See "Controls and Functions" on page 537
SOURce<Ch>:GROup<Grp>:NAME <GroupName>
Sets/gets the name of port group <Grp>.
Port groups can be created using SOURce<Ch>:GROup<Grp>:PPORts.
Suffix:
<Ch>
.
Channel number
<Grp> Port group number
Parameters:
<GroupName> Group name
Example: See SOURce<Ch>:GROup<Grp>:PPORt<PhyPort>:DPORt
Manual operation: See "Controls and Functions" on page 537
SOURce<Ch>:GROup<Grp>:PORDer <PortOrder>
R&S ZNBT only!
Sets or queries the drive port order of the related DUT (= port group, created using
SOURce<Ch>:GROup<Grp>:PPORts)
Suffix:
<Ch>
.
Channel number
<Grp> DUT (port group) number
Parameters:
<PortOrder> By default (empty string) the ordering of the related physical
VNA ports is used. An alternative drive port ordering can be
specified as a complete, comma-separated list of the related
DUT port numbers.
*RST: empty string
Example: Suppose DUT 1 in channel 1 has 4 ports.
:SOURce1:GROup2:PORDer '1,3,2,4'
In the first sweep DUT port 1 will be driven, in the second sweep
DUT port 3, in the third sweep DUT port 2 and in the fourth
sweep ports 4.
Manual operation: See "Controls and Functions" on page 537
SCPI Command Reference