Command Reference
R&S
®
ZNB/ZNBT
1260User Manual 1173.9163.02 ─ 55
SOURce<Ch>:GROup<Grp>:PORTs <arg0>, <arg1>...
Defines the set of active logical ports (the "master group") as an arbitrary selection of
logical ports. The ports do not have to be numbered consecutively (as for port groups
defined via SOURce<Ch>:GROup<Grp>).
See SOURce<Ch>:LPORt<LogPt> on how to define logical ports.
Note:
Setting SOURce<Ch>:GROup<Grp> or SOURce<Ch>:GROup<Grp>:PORTs dissolves
the port groups created using SOURce<Ch>:GROup<Grp>:PPORts (R&S ZNBT only).
Suffix:
<Ch>
.
Channel number.
<Grp> In "set direction" this must be 1 (or omitted). In "get direction"
also port groups created using SOURce<Ch>:GROup<Grp>:
PPORts can be queried (R&S ZNBT only).
Parameters:
<arg0>
<arg1> Logical port numbers. Must be omitted if the command is used
as a query.
SOURce<Ch>:GROup<Grp>:PPORts <pport1>,<pport2>...
Defines/queries port groups.
In "set direction" this command creates port group <Grp> from physical VNA ports
<pport1>, <pport2>, .... In "get direction" it returns the physical VNA ports
making up group <Grp>.
Note
●
Port groups must be created in ascending order, i.e. first create port group 1, then
port group 2 etc.
●
By default there is a single port group, which contains all physical VNA ports
("default port group").
●
Redefinition of an existing port group is not allowed (exception: "default port
group"). Use SOURce<Ch>:GROup<Grp>:CLEar to dissolve existing port groups
first.
●
It is not allowed to assign the same physical VNA port to multiple port groups.
●
When a port group is created, the number of ports of the corresponding DUT is set
to the port group size and "aligned" port connections are etablished.
The result can be modified using SOURce<Ch>:GROup<Grp>:DPORt:COUNt and
SOURce<Ch>:GROup<Grp>:PPORt<PhyPort>:DPORt (R&S ZNBT only).
Suffix:
<Ch>
.
Channel number
<Grp> Port group number
SCPI Command Reference
To Next Page
Loading...
