R&S ZNB - Page 1319

Command Reference
R&S
®
ZNB/ZNBT
1319User Manual 1173.9163.02 ─ 55
Manual operation: See "Edit Test Port Connection" on page 737
SYSTem:COMMunicate:RDEVice:SMATrix:COUNt?
Gets the number of configured switch matrices (see SYSTem:COMMunicate:
RDEVice:SMATrix<Matr>:DEFine on page 1319)
Usage: Query only
Manual operation: See "Configured Devices" on page 731
SYSTem:COMMunicate:RDEVice:SMATrix:DELete
Unregisters all switch matrices, i.e. removes them from the list of configured devices.
Example:
See SYSTem:COMMunicate:RDEVice:SMATrix:
CONFigure:STARt
Usage: Event
Manual operation: See "Delete All" on page 733
SYSTem:COMMunicate:RDEVice:SMATrix:SCAN?
Scans for external switch matrices connected via USB or Direct Control.
Returns a comma separated list
<Driver_1>,<Interface_1>,<Address_1>,...,<Driver_N>,
<Interface_N>,<Address_N>, one triple
<Driver_n>,<Interface_n>,<Address_n> for each detected switch matrix
<Matr>=1,...,N.
Use SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine to configure them.
Usage:
Query only
Manual operation: See "Scan Instruments" on page 731
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine <Unused>, <Driver>,
<Interface>, <Address>
This command allows
●
to configure (i.e. register) a new switching matrix
●
to modify the (management) connection settings of an already configured switching
matrix
●
to get the (management) connection settings of a configured switching matrix
Suffix:
<Matr>
.
Index of the switch matrix.
Switch matrices are numbered in ascending order, starting with
1. If a number is re-used, the current configuration is overwritten.
SCPI Command Reference