Command Reference
R&S
®
ZNB/ZNBT
1361User Manual 1173.9163.02 ─ 55
Parameters:
<Expression> <expr>
(<operand1><operator1><operand2>[<operator2>
<operand3>]) The expression must be enclosed in brackets.
Operands: See list of trace names in Chapter 8.3.18, "TRACe
Commands", on page 1343.
Operators: +, -, *, /
Example:
*RST; CALC:MATH:MEM
Copy the current state of the default trace Trc1 to a memory
trace named "Mem2[Trc1]". The memory trace is not displayed.
CALC:MATH (CH1DATA / MDATA2)
Define a mathematical trace, dividing the data trace by the
stored memory trace. The mathematical trace is not displayed
CALC:MATH:STAT ON
Display the mathematical trace instead of the active data trace.
DIAGnostic:SERVice:FUNCtion <SFId1>, <SFId2>...
Activates a service function (mainly for internal use). Service functions are identified by
groups of numbers, separated by dots.
Parameters:
<SFId1>
<SFId2> Service function identifier entered as a (pseudo-)numeric value,
the dots being replaced by commas. Five groups of numbers are
allowed at maximum. See also DIAGnostic:SERVice:
SFUNction.
FORMat:DEXPort:SOURce <Format>
Defines the format for traces retrieved with the R&S ZVR-compatible command
TRACe[:DATA][:RESPonse][:ALL]?.
This command is not relevant for results read with the CALCulate<Chn>:DATA...
commands.
Parameters:
<Format> FDATa | SDATa | MDATa
See list of parameters below. The unit is the default unit of the
measured parameter; see CALCulate<Ch>:PARameter:
SDEFine.
Range: Depending on the measured parameter and format.
*RST: SDATa
Example: See TRACe[:DATA][:RESPonse][:ALL]?
The following parameters are related to trace data:
R&S ZVR/ZVABT Compatible Commands
To Next Page
Loading...
