MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-10 SM
006 Low Limit (High Temp Mode)
Sets the low limit for the fusing temperature in high temperature mode. If the fusing
temperature falls below this temperature while operating in the high temperature
mode, the machine will stop. After the fusing temperature rises above this
temperature, the machine resumes operation in high temperature mode.
[120~180/*/1 deg C]
* B234/D101: 128
* B235/D102: 140
* B236/D103: 153
007 Fusing Temp Correction: Small
Sets the amount to raise the fusing temperature above the standby temperature to
print on paper sizes smaller than A4/LT LEF.
[0~20/10/ 1 deg C]
Note: You can use SP1105 011 to lower the threshold for the small size to B5.
008 Fusing Temp Correction: Normal
Sets the amount to raise the fusing temperature above the standby temperature to
print on paper sizes A4/LT and wider.
[0~10/5/1]
Note: If the threshold paper size is lowered to B5 with SP1105 013, this 008 takes
effect for paper sizes wider than B5.
009 Fusing Temp Correction (Translucent Sheets)
Specifies the amount to raise or lower the fusing from the standby temperature to
print on translucent paper.
[-10 ~ +10/0/ 1 deg C]
010 Fusing Lamp Switching (at Warm-up)
Specifies the fusing temperature at which 1 lamp of the 3 fusing lamps is switched
off. The lamp that is switched off is the one heating the center of the hot roller.
Switching this lamp off prevents overshooting the warm-up temperature.
[20~190/*/1 deg C]
* B234/D101: 99
* B235/D102: 99
* B236/D103: 95
011 Fusing Temp Adjustment (Low Power Mode)
Sets the target temperature of the hot roller for low power mode. The hot roller
remains at this temperature until the machine leaves low power mode.
[20~170/*/1 deg C]
* B234/D101: 95
* B235/D102: 107
* B236/D103: 107
012 Fusing Idling Start Temp
Sets the temperature at which fusing idling starts. Fusing idling rotates the hot roller
with no paper feed to ensure that the hot roller heats uniformly.
[100~160/160/1 deg C]
013 Select Paper Size for Temp Correction (0:LT,1:B5)
Sets the paper size used to define "small paper" for SP codes 1105 007, SP1105
008.
[0~1/1/1]
0: LT/A4 LEF
1: B5 LEF (257 mm wide)
To Next Page
Loading...
