MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-12 SM
1109 Fusing Nip Band Check
Use OHP to execute this SP and feed 1 sheet between the hot roller and pressure
roller where it remains for 30 s and is then fed out so you can measure the nip band
width.
[OFF, ON]
Note: This SP must be switched off after the nip band check is completed. If this SP
remains on, this will cause paper to jam in the fusing unit (SC559).
1159 Fusing Jam: SC Setting
This SP determines what the machine does if paper jams occur in the fusing unit for
three consecutive sheets of paper.
0 (default): A jam alert is shown on the screen. The customer can remove the jam and
the machine works normally after that.
1: SC559 occurs. The technician must remove the jam.
1902 Web Motor Control
001 Web Consumption
Displays how much of the web has been used, expressed as a percentage of the
roll consumed. Switch the machine off/on after changing this setting.
[0~107 / 0 / 1%]
When you install a partially used roll from another machine, read this SP before
removal, then input that value with this SP on the next machine. Otherwise, the
machine has no way of knowing how much of the partially used roll has been
consumed.
002 Web Motor Drive Interval
Determines how often the web motor turns on.
[3 to 130/*/0.1 sec.]
Note: The default setting is different depending on the area and model (see below).
Model NA EU/Asia
B234/D101
19.8 13.2
B235/D102
16.2 10.8
B236/D103
12.9 8.6
003 Web Motor Drive Time
Changes the time that the web motor is driven.
[0.3~3.5 / 2.8 / 0.1 s]
004 Web Near End Setting
Changes the web consumption ratio at which web near end is displayed.
EUR/A: [0~100 / 90 / 1%]
NA: [0~100 / 92 / 1%]
005 Web Motor Drive Interval (Low Speed)
Determines how often the web motor turns on in Low Speed mode.
[3~130/*/0.1s]
Note: The default setting is different depending on the area and model (see below).
Model NA EU/Asia
B234/D101
19.8 13.2
B235/D102
19.8 13.2
B236/D103
16.2 10.8
To Next Page
Loading...
