MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-18 SM
2105 LD Power Correction
These SP codes correct the banding caused by: 1) changes in drum characteristics over
time, and 2) LD power fluctuations.
001 Correction in Printer Mode
If switched ON, this allows each channel to be adjusted for 1200 dpi print output with the
SP settings below (LD0 ~ LD7).
[0~1 / 1 / 1]
0: OFF, 1: ON
002 Correction in Copy Mode
If switched ON, this allows each channel to be adjusted for copy output with the SP
settings below (LD0 ~ LD7).
[0~1 / 0 / 1]
0: OFF, 1: ON
003 LD0 Power Correction
Correct the power of LD0 after either SP2105-001 or -002 is switched on.
[-40~+40 / -2 /1]
004 LD1 Power Correction
Corrects the power of LD1 after either SP2105-001 or -002 is switched on.
[-40~+40 / -2 /1]
005 LD2 Power Correction
Corrects the power of LD2 after either SP2105-001 or -002 is switched on.
[-40~+40 / +2 /1]
006 LD3 Power Correction
Corrects the power of LD3 after either SP2105-001 or -002 is switched on.
[-40~+40 / +2 /1]
007 LD4 Power Correction
Corrects the power of LD4 after either SP2105-001 or -002 is switched on.
[-40~+40 / +2 /1]
008 LD5 Power Correction
Corrects the power of LD5 after either SP2105-001 or -002 is switched on.
[-40~+40 / +2 /1]
009 LD6 Power Correction
Corrects the power of LD6 after either SP2105-001 or -002 is switched on.
[-40~+40 / -2 /1]
010 LD7 Power Correction
Corrects the power of LD7 after either SP2105-001 or -002 is switched on.
[-40~+40 / -2 /1]
To Next Page
Loading...
