Ricoh B234 - Page 557

Main Service Program Mode Tables
SM 5-19 B234/B235/B236/D101/D102/D103
Service
Tables
2111 FCI Shade Detection
Allows shading detection if FCI (Fine Character Adjustment) smoothing is on. With this
SP switched on, photos and painted areas are detected, and FCI is not applied in these
areas. FCI is used for printer mode output only.
001 Matrix Size (600 dpi) [0~128 / 18 / 1]
0: OFF
002 Threshold Value (600 dpi) [0~128 / 4 / 1]
0: OFF
003 Matrix Size (400 dpi) [0~128 / 18 / 1]
0: OFF
004 Threshold Value (400 dpi) [0~128 / 4 / 1]
0: OFF
2114 Printer Dot Edge Parameter Setting
Allows setting a parameter for binary edge processing for the printer application with
FCI switched off. This SP allows adjustment of image quality if the desired effect cannot
be achieved with the default settings for edge processing. In general, increasing the
values produces thicker lines and decreasing them produces thinner lines. However,
some settings could cause defective images on white paper.
001 Leading Dot Level Setting (1200 dpi) [2~8 / 5/ 1]
002 Trailing Dot Level Setting (1200 dpi) [2~8 / 5/ 1]
003 Multiple Dot Level Setting (1200 dpi) [2~8 / 8 / 1]
004 Independent Dot Level Setting (1200 dpi) [2~8 / 6/ 1]
005 Leading Dot Level Setting (600 dpi) [2~16 / 12/ 1]
006 Trailing Dot Level Setting (600 dpi) [2~16 / 12/ 1]
007 Multiple Dot Level Setting (600 dpi) [2~16 / 16/ 1]
008 Independent Dot Level Setting (600 dpi) [2~16 / 12/ 1]