Ricoh B234 - Page 606

MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-68 SM
162 Connection Timing Adjustment: Incoming
When the Call Center calls out to a Cumin-M modem, it sends a repeating ID
tone (*#1#). This SP sets the line remains open to send these ID tones after the
number of the Cumin-M modem is dialed up and connected.
[0~24/1/1]
The actual amount of time is this setting x 2 sec. For example, if you set "2" the
line will remain open for 4 sec.
163 Access Point
This is the number of the dial-up access point for Cumin-M. If no setting is done
for this SP code, then a preset value (determined by the country selected) is
used.
Default: 0
Allowed: Up to 16 alphanumeric characters
164 Line Connecting
This SP sets the connection conditions for the customer. This setting dedicates
the line to Cumin-M only, or sets the line for sharing between Cumin-M and a
fax unit.
[0~1/0/1]
0: Line shared by Cumin-M/Fax
1: Line dedicated to Cumin-M only
Note:
• If this setting is changed, the copier must be cycled off and on.
• SP5816 187 determines whether the off-hook button can be used to interrupt
a Cumin-M transmission in progress to open the line for fax transaction.
173 Modem Serial Number
This SP displays the serial number registered for the Cumin-M.
174 Retransmission Limit
Normally, it is best to allow unlimited time for certification and ID2 update
requests, and for the notification that the certification has been completed.
However, Cumin-M generates charges based on transmission time for the
customer, so a limit is placed upon the time allowed for these transactions.
If these transactions cannot be completed within the allowed time, do this SP to
cancel the time restriction.
187 FAX/TX Priority
This SP determines whether pushing the off-hook button will interrupt a Cumin-
M transmission in progress to open the line for fax transaction. This SP can be
used only if SP5816 164 is set to "0".
[0~1/0/1]
0: Disable. Setting the fax unit off-hook does not interrupt a fax transaction in
progress. If the off-hook button is pushed during a Cumin-M transmission, the
button must be pushed again to set the fax unit on-hook after the Cumin-M
transmission has completed.
1: Enable. When Cumin-M shares a line with a fax unit, setting the fax unit off-
hook will interrupt a Cumin-M transmission in progress and open the line for a
fax transaction.
Regist: Status
Displays a number that indicates the status of the NRS service device.
0 Neither the NRS device nor Cumin device are set.
1 The Cumin device is being set. Only Box registration is completed. In this
status the Basil unit cannot answer a polling request.
2 The Cumin device is set. In this status the Basil unit cannot answer a
polling request.
3 The NRS device is being set. In this status the Cumin device cannot be set.
201
4 The NRS module has not started.