MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-70 SM
-2391 Two registrations for same device
-2392 Parameter error
-2393 Basil not managed
-2394 Device not managed
-2395 Box ID for Basil is illegal
-2396 Device ID for Basil is illegal
-2397 Incorrect ID2 format
-2398 Incorrect request number format
209 Remote Setting Clear
Releases a machine from its Cumin setup.
250 CommLog Print
Prints the communication log.
5821 Remote Service Address Japan Only
001 CSS PI Device Code
Sets the PI device code. After you change this
setting, you must turn the machine off and on.
002 RCG IP Address
Sets the IP address of the RCG (Remote
Communication Gate) destination for call processing
at the remote service center.
[00000000h~FFFFFFFFh/1]
5824 NVRAM Data Upload (Refer to IMPORTANT NOTE in Sect. 5.10.6)
Uploads the UP and SP mode data (except for counters and the serial number)
from NVRAM on the control board to an SD card.
Note: While using this SP mode, always keep the front cover open. This
prevents a software module accessing the NVRAM during the upload.
5825 NVRAM Data Download
Downloads data from an SD card to the NVRAM in the machine. After
downloading is completed, remove the SD card and turn the machine power off
and on.
⇒
Rev. 07/09/2009
To Next Page
Loading...
