Main Service Program Mode Tables
SM 5-71 B234/B235/B236/D101/D102/D103
Service
Tables
5828 Network Setting
050
1284 Compatibility
(Centro)
Enables and disables bi-directional communication on
the parallel connection between the machine and a
computer.
[0~1/1]
0:Off
1: On
052 ECP (Centro)
Disables and enables the ECP feature (1284 Mode) for
data transfer.
[0~1/1]
0: Disabled
1: Enabled
065 Job Spool Setting Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
066 Job Spool Clear
This SP determines whether the job interrupted at
power off is resumed at the next power on. This SP
operates only when SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
This SP determines whether job spooling is enabled or
dispabled for each protocol. This is a 8-bit setting.
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
069 Job Spool Protocol
3 SMB 7 Reserved (Not Used)
084
Print Settings List
Prints a list of the NCS parameter settings.
090
TELNET (0:OFF 1:ON)
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
091
Web (0:OFF 1:ON)
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
092
Primary WINS Server
IPv4 Address
This SP is used to set and later refer to the WINS IPv4
primary address used by the Ethernet or the wireless
LAN (802.11b). The current address is displayed and
printed in the SMC report as aaa.bbb.ccc.ddd and is
entered as 8-bit data. For example, if the number
"192.168.000.001" is entered, it is recorded as
"0C0A80001h".
To Next Page
Loading...
