Ricoh B234 - Page 610

MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-72 SM
096 This SP disables/enables Rendezvous operation.
This is a set of protocols that allows a device on an IP
network to automatically recognize and connect with
other devices (such as a printer) on a network. Once a
new device is connected to the network, it can be used
immediately by every computer on the network. No
special setup procedures or configuration settings are
required
1: Enable 0: Disable
145
Operation IPv6 Link
Local Address
This is the IPv6 local address link referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Link Local Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
147
Operation IPv6 Status
Address 1
149
Operation IPv6 Status
Address 2
151
Operation IPv6 Status
Address 3
153
Operation IPv6 Status
Address 4
155
Operation IPv6 Status
Address 5
These SPs are the IPv6 status addresses (1 to 5)
referenced on the Ethernet or wireless LAN (802.11b)
in the format:
"Status Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
156
IPv6 Manual Setting
Address
This SP is the IPv6 manually set address referenced
on the Ethernet or wireless LAN (802.11b) in the
format:
"Manual Set Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
157
Operation IPv6
Manual Setting
Address
This SP is the operation IPv6 manually set address
referenced on the Ethernet or wireless LAN (802.11b)
in the format:
"Operation Set Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
158
IPv6 Gateway
Address
This SP is the IPv6 gateway address referenced on the
Ethernet or wireless LAN (802.11b). The IPv6 address
consists of a total 128 bits configured in 8 blocks of 16
bits each.
159
Operation IPv6
Gateway Address
This SP is the IPv6 operation gateway address
referenced on the Ethernet or wireless LAN (802.11b).
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
162
IPv6 Access Control
Display
This SP enables the display for access control of the
IPv6 addresses.
Initial Setting Mode Clear 5831
Push [Execute] to restore the initial settings of all SP codes to their initial
(factory) settings.
Note: This SP does not reset time settings or user tool settings.