MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-92 SM
6100 Staple Position Adjustment
Use this SP to shift the position of the stapling done by the corner stapler of the
finisher (B830). This SP shifts the staple position forward and back across the
direction of paper feed.
• Use the “•” key to toggle between + and –.
• A larger value shifts the stapling position to shift forward.
• A smaller value shifts the stapling position backward.
001 A3 SEF
002 B4 SEF
003 A4 SEF
004 A4 LEF
005 B5 SEF
006 B5 LEF
007 DLT
008 LG
009 LT SEF
010 LT LEF
011 Custom Size
The settings are done for each paper size.
SEF denotes "Short Edge Feed".
LEF denotes "Long Edge Feed".
[-2 to +2 / 0 / 0.5 mm]
6101 Punch Hole Position Adjustment
Use this SP to shift the position of the punching done by the Punch Unit B831. This
SP shifts the punching position left and right in the direction of paper feed. There are
three versions of the Punch Unit B831 1) NA 2/3 (2 or 3 hole punching selectable for
the job), 2) NA 4 (4 hole punching only), and 3) EU 2/4 (2 or 4 hole punching
selectable for the job)
[-7.5~+7.5 / 0 / 0.5 mm]
• Use the “•/*” key to toggle between + and –.
• A larger value shifts the punch holes away from the edge of the paper.
• A smaller value shifts the punch holes toward the edge of the paper.
001 2-Hole: JPN Japan Only
002 3-Hole: NA North America, 3-hole punching
003 4-Hole: Europe Europe, 4-hole punching
004 4-Hole: NA North America, 4-hole punch
005 2-Hole: NA North America, 2-hole punching
006 1-Hole: JPN Japan Only
To Next Page
Loading...
