MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-98 SM
6504 Adj Jog: Punching Ring Binder D392
1 A4 LEF
2 LT LEF
Shifts the punch hole position horizontally (front-to-rear, rear-to-front)
[-4 to +4/0/0.1 mm]
This SP must be adjusted after replacement of one or more of the following
items:
• Ring binder main board
• Binder unit control board
• Pre-punch side jogger assembly
• Pre-punch jogger HP sensor (S301)
Notes:
The correct value for this setting is written on the label attached to the pre-
punch jog unit.
The value must be divided by "10". For example, "19" is actually "1.9 mm)
6505 Adj Jog: Paddle Ring Binder D392
Adjusts the height of the paddle roller at initialization. If the correct number is not
entered, the stack will not be jogged correctly before binding.
[-3 to +3/0/0.1 mm]
This SP must be adjusted after replacement of one or more of the following items:
• Ring binder main board
• Binder unit control board
• Pre-bind jogger unit
The correct value to be entered for the adjustment is written in the first line of the
label. This label is attached to the front cover of the pre-bind jogger unit.
Note: The value must be divided by "10". For example, "8" is actually "0.8 mm)
To Next Page
Loading...
