Overview of parameters
Parameters
1-13
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Changeable
The "-" sign indicates that the parameter can be changed in any object state and
that the change will be effective immediately.
The information "C(x), T, U" ((x): optional) means that the parameter can be
changed only in the specified drive unit state and that the change will not take
effect until the unit switches to another state. One or more states are possible.
The following states may be specified:
Table 1-2 Possible combinations of BICO interconnections
BICO input parameter
CI parameter BI parameter
BICO output parameter Unsigned32 /
Integer16
Unsigned32 /
Integer32
Unsigned32 /
FloatingPoint32
Unsigned32 /
Binary
CO: Unsigned8 x x – –
CO: Unsigned16 x x – –
CO: Unsigned32 x x – –
CO: Integer16 x x r2050 –
CO: Integer32 x x – –
CO: FloatingPoint32 x x x –
BO: Unsigned8 – – – x
BO: Unsigned16 – – – x
BO: Unsigned32 – – – x
BO: Integer16 – – – x
BO: Integer32 – – – x
BO: FloatingPoint32 – – – –
Legend: x: BICO interconnection permitted
–: BICO interconnection not permitted
• C(x) Commissioning C: Commissioning
Drive commissioning is in progress (p0010 > 0).
Pulses cannot be enabled.
The parameter can only be changed in the following drive commission-
ing settings (p0010 > 0):
C: Changeable for all settings p0010 > 0.
C(x): Only changeable for the settings p0010 = x.
A modified parameter value does not take effect until the device com-
missioning mode is exited with p0010 = 0.
To Next Page
Loading...
