Chapter 5
Maintenance and Repair
P/N 57150002, Revision 5.0 5 - 51 Trimble S, VX, SPS & RTS Service Manual
F
Fig. 5-48 Removing servo side axle
8 Clean the axle and the
bearing.
Wipe the axle and
bearing clean with dry
paper.
9 Regrease the axle and
bearing.
Apply a laurel of grease
on the axle and
bearing.see Fig. 5-49 on
page 5-51
Fig. 5-49 Servo side axle and bearing greasing
10 Mount the vertical axle Use a torque wrench
with a torx T10 bit and
tighten the four screws
crosswise to 140 Ncm /
12,4 lbfin. Remove all
excessive grease.
11 Mount the MSB board.
12 Mount angle disc and
SRC board.
Mount angle disc and
SRC board incl. magnets
together.
13 Mount Telescope pre-
load unit.
14 Mount IPC board.
15 Mount servo side cover.
Item Performance Action Result Notes
To Next Page
Loading...