6. EM GUI orientation
6.11 Configuration Menu > Adjustment area
General
Situated on the right hand side of the screen is the Adjustment area. In this area the user can define and adjust unit specific param-
eters, inputs, backgrounds, outputs, multiviewer outputs and destination affected to the selected system.
Description
There are 4 tabs in this area:
• Input: this tab pr ovides a list of all the created inputs. Here
the user c an create new entries by as sociating them with
input connectors. It is also in this tab that the user can
delete unused or obsolete inputs.
• Backgrou nd: provides a list of backgrounds of the selected
system. Similarly to inputs, the user c an add and remove
Backgrounds from the system.
• Output/M VR: the user can add or remo ve program,
auxiliary and m ultiviewer outputs in this list.
• Destination: a destination is a location where the user can
route the output of Event Mas ter series processor (screens,
widescreens, monitors etc.). T he user could assign the
outputs that are created in the previous tab to des tinations,
and deleted unus ed or obsolete destinations
Always on top:
• Adjustment: in this tab the user performs adjustments
available for the selected item (device, input, background,
output, destination). The content of this tab varies
depending on the selected item. Access to this area is
achieved from the System diagram area (click on device
or on a destination) or in one of the tabs of the Adjustment
area (input, background, output, destination) .
The following sections describe how to perform the configuration of each part of the system in detail:
•"Configur ation Menu > Adjustment > Unit Configuration", page 105
•"Configur ation Menu > Adjustment > Input Con figuration", page 107
•"Configur ation Menu > Adjustment > Background Configuration", page 116
•"Configur ation Menu > A djustment > Output Configuration", page 118
•"Configur ation Menu > Adjustment > Destination Configuration", page 126
104
R5905948 EVENT MASTER DEVICES 17/07/2017
To Next Page
Loading...
