6. EM GUI orientation
6.30 Multiviewer (MVR) Menu
General
The last card slot on an E vent Master processor—for example, Slot #14 on an E2, or Slot #9 on an S3–4K—m ay be either a normal
Output slot or a dedicated M ultiviewer. (See the description of the Setup tab in "Configuration Menu > Adjus tment > Unit Configur a-
tion", page 105 for instructions on how select this slot as either an O utput slot or a Mu ltiviewer slot.)
A Multiviewer ena bles m ultiple s ources (inputs, Backgrounds, outputs) to b e displayed on one or two m onitors. S creen Destinations
(Program and P review) can be used up to two times in any Multiviewer Output. T he position of the window for ea ch copy can
be different, but the size of the w indow for each copy is always the sa me." Multiviewer Menu is the module used to setup the
Multiviewer outputs.
Description
This m enu is accessible by clicking the Multiviewer icon in the menu bar on the left side of the UI.
The three drop-down menus in the title b ar select the system, unit or layout displayed in the multiviewer. For release one, only one
system and one unit are supported.
The M ultiviewer page is divided in four parts.
Image 6-76
1 Resources area Lis ts the resources available to b e displayed in the
Multiviewer: Inputs, Backgrounds and Program/Pre view
Destination Outputs.
2 Multiviewer Lay out ar ea The two multiviewer outputs are composed, viewed and
managed individually or as a group.
3
Modifier area
Alignment adjustments and controls to manage the
multiviewer outputs
4 Adjustment area
Color and sizing adjustments for the window s in each PIP.
The following sections describe each part of the Multiviewer page in detail:
• "Multiviewer Menu > Resource a rea", page 193
• "Multiviewer Menu >
Multiviewer Layout area", page 194
• "Multiviewer Menu > Mo difier a rea", page 196
• "Multiviewer Menu > Adjustment ar ea", page 197
192
R5905948 EVENT MASTER DEVICES 17/07/2017
To Next Page
Loading...
Need help?
General
