Barco S3 User Manual

7. System Setup
7.9 Backing up the system
General
In this procedure, you will back up you r system configuration to a US B drive.
Prerequisite
• Ensure that you are familiar with the USB device (Backup/Restore) Menu. F or details on this m enu, please refer to chapter
"System men u > USB device (Backup/Restore)", page 72.
Back up a system configuration file
Use the following steps to back up your system to a US B Drive:
1. Insert a formatted flash drive in the unit’s front-panel USB port.
2. From the System me nu, scroll to the US B Backup/Restore submenu. Selec t Backup Confi g.
The USB Backup Co nfig submenu appears. T he navigation cursor appears at the default name for the first backup file.
3. If y ou wish to change the default name of the backup configuration, press SEL.UsetheADJUST knob to ch ange the name, as
described in section "Using menu system", page 66 . Press SEL again when you complete the name change.
4. Scroll to Backup Config and press SEL.
Aconfirmation mes sage appears when the bac kup is complete.
228
R5905948 EVENT MASTER DEVICES 17/07/2017

Barco S3 Specifications

General

Brand	Barco
Model	S3
Category	Computer Hardware
Language	English