7. System Setup
7.4 Return to factory default
General
Prior to performing any setup procedures, it is recommended that you perform a factory reset — in order to reset all input, output
and source mappings to their default values.
Particularly for customers in the eve nts and rental marketplace, this procedure guarantees that any previous input setups and mem -
ory registers (e.g., those that may have been programm ed by other users) are c ompletely cleared from system mem ory.
If you are continuing an e vent (for example, day two of a three-day event), you do not need to p erform a factory
reset. However, if yo u do elect to perform a factory reset, ensu re that you have b acked u p your system. for
details, p lease refer to the procedure "Backing up the system", page 228.
Prerequisite
• Ensure that y ou are familiar with the Reset Menu . For details o n all menus, please r efer to cha pter "Restoring Factory Default
Settings", pa ge 83.
Restoring factory settings
To restore all default settings to the Event Master series processor, use the following pro cedure:
1. Select Factory Reset from the Setup Menu.
The Factory Reset Menu appears.
2. Select Factory Reset to reset the entire system to its factory default values. Rem em ber that all data will be lost.
Or,
Select Factory Reset, Save IP to rese t the entire system to its factory default values, but retains the IP address of the unit.
A prom pt appears, asking if you want to clear all configurations.
3. Press SEL.
The system turns off, then it reboots.
R5905948 EVENT MASTER DEVICES 17/07/2017
223
To Next Page
Loading...
Need help?
General
