12. Controller Operation
12.5 How to select destinations
General
Once the row of Destination buttons have been mapped they can be used to select or deselect them.
A range of actions can be performed with this selection:
• Transition via Cut or A ll-Trans.
• Included in the record of a P reset;
• Prepare the destination for Layer manipulation.
• Change time of the destinations Transition. N ote: time is assigned to eac h destination individually.
In general it c an be said t hat the selected Destination via the console have the same actions av ailable as in the Event Master Toolset,
just in a m ore hands-on direct way.
328
R5905948 EVENT MASTER DEVICES 17/07/2017
To Next Page
Loading...
