Barco S3 User Manual

12. Controller Operation
12.11 How to use the T-bar
General
The T-bar is the way to manually transition Destinations. I t works b oth ways to trans ition the set up pre-view into pr ogram. In the
case a transition is not completed it c an be reversed . A m anually started transition can be finished with an All-Trans command.
Only selected destinations will be concerned by the T-bar use. The non selected dest inations are not affected
by the t r a nsition .
334 R5905948 EVENT MASTER DEVICES 17/07/2017

Barco S3 Specifications

General

Brand	Barco
Model	S3
Category	Computer Hardware
Language	English