Barco S3 User Manual

1. Introduction
1.2 Record of changes
Overview
Revision Changes
00 Initial version
01
• Changes initiated by:
- New sof tware version (V2.0).
- S3-4K and EC-50 product releases.
• In the en tire of the doc ument, the references to E2 have been replaced by reference to the Event
Master processors.
• A record of cha nges (this section) has been added.
• S3–4K product has b een added. Chapters concerned by this new Event Master processor have
been modified:
- Description in General ch apter + How to install S3 in a rack.
- Detailed explanations concerning new h ardware in the Hardw are Orientation c hapter.
• EC–50 product has been add ed. Chapters concerned by this new controller have been modified
or added:
- Description in General chapter.
- New chapters dedicated to Co ntr oller Orientation, Controller Configuration and Controller
Operation.
• A new version off Event Master Toolset is available (V2.0). The GUI orientation chapter and the
System setup procedure have been updated.
• Two units can be linked. A section in the GUI orientation c hapter describes how set u
p a linked
System.
• A new chapter c oncerning the maintenance of the S3–4K has been added.
• A new chapter concerning the maintenan ce of the EC–50 controller has been adde d.
• Annex:
- New section with S3 specifications.
- Remote command ATRN updated.
- New chapter “THIRD PARTY SO F TWARE ACKNOWLEDG E ME NTS” added.
02
• Changes initiated by:
- New sof tware version (V3.0).
- EC-200 product release.
• EC–200 product has been added. C hapters concerned by this new controller have been modifi ed
or added:
- Description in General chapter.
- New chapters dedicated to Co ntr oller Orientation, Controller Configuration and Controller
Operation.
•TheFront Panel Menu o rientation chapter has been updated:
- a modification in the front men u panel of the "E vent Master Processor" to take into account a
configuration created offline and transferred via USB device.
• A new version off E vent Master Toolse t is av ailable (V3.0). The GUI orie ntation chapter has been
partially updated. A more complete update of this chapter will be performed at the next version
of the document.
- Win 10 has been ad ded in the list of O perating Systems that acce pts the "Event Master Toolset"
Software.
- A n ew s ection de scribes the Controller menu.
• A new c hapter concerning the maintenance of the E C–200 controller has been added.
• Annex:
- New s hort section with EC-50 specifications.
03
• Changes initiated by:
- New software version (4.0).
- EX, E2 Jr., and S3–4K Jr. product releases.
• Updated RoHS table, taking into account the March 2016 changes.
R5905948 EVENT MASTER DEVICES 17/07/2017 9

Barco S3 Specifications

General

Brand	Barco
Model	S3
Category	Computer Hardware
Language	English