14. S3 Maintenance
Image 14-42
2. Gently pull the G enloc k assembly a way from the unit . Don’t pull the assembly too far back because there are s till 2 cables
attached.
Note: At this point there are s till 2 cables connecting the G enloc k Assem bly to the unit.
3. Unlatch the Genlock ribbon cable from the connector and pull it up and away from the Genloc k board.
Note: This cable connects the Genlock board to the Motherboard.
Image 14-43
4. Unlatch the Ethernet cable from the connector and pull back and away from the G enlock board.
Note: This cable connects the Genlock board to the Motherboard.
How to install the Genloc k Assembly
To install the Genlock Assem bly follow the sam e procedure in the reverse order.
R5905948 EVENT MASTER DEVICES 17/07/2017
443
To Next Page
Loading...
