low: Fast speed / low scan density This mode is selected only in case of expected
movement artefacts. A loss of volume resolution will result.
mid 2: Standard VOL scan / medium scan density
max: Slow speed / high scan density
8. To start 3D acquisition press the [Freeze] key or the right trackball key (Start -> displayed in
Status bar area on the monitor).
The volume acquisition starts, then the acquired images are displayed.
'During 3D Acquisition'
on page 9-20
'3D Acquisition During Active High Resolution Zoom'
on page 9-19
The “3D” menu appears on the menu area (scan mode).
Volume Mode
9-50
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
To Next Page
