iPECS UCP
Feature Description and Operation Manual Issue 1.3
145
2. System will provides data/time prompt of the message.
SLT
1. Lift the handset.
To retrieve Voice Mail locally
2. Dial the Voice Mail Group to receive the Mailbox number and Password prompts.
3. Dial the Mailbox and corresponding password to receive the “Number of Messages”
prompt.
4. Dial desired option code.
5. At completion of session, hang-up to return to idle.
1. During or after the New or Old Message option prompt, dial “7”.
To attach a memo to the current voice message
2. At the beep, record the memo.
3. Dial “*” to stop and store the memo.
4. During or after the New Old option prompt, dial “4” to forward the message and
memo.
Conditions
1. If no new/old messages are available, pressing “1” or “2”, is an invalid operation
and you will receive the “Invalid Entry” prompt or “No Message” prompt.
2. If the dialed number is not recognized, the "Invalid Entry" prompt is played. After
the second invalid entry, you are disconnected.
3. You may dial digits at any time during a voice mail playback, system prompt or
silence. You must dial a digit in response to a system prompt within the CCR Inter-
digit timer or the Voice Mail will disconnect and return error tone.
4. Messages can be retrieved in either a FIFO (First in First out) or LIFO (Last in First
out) order to meet the desire of each user.
5. If your Mailbox is configured with Auto Save New Message, after listening to the
message, the message is stored and you must be expressly delete the message.
To minimize the potential for large amounts of unwanted stored messages, Auto
Save New message can be disabled then the message is deleted if not expressly
saved.
Programming
To Next Page
Loading...
