iPECS UCP - Page 215

iPECS UCP
Feature Description and Operation Manual Issue 1.3
203
2. Dial “555”, the SLT Speed Dial assignment code.
3. Dial the Speed Dial bin number (“00”-“99”).
4. Dial the Line access code.
5. Dial the number to be stored.
6. Momentarily press the hook-switch.
7. If desired, enter a name, see alphanumeric entry chart below.
8. Momentarily press the hook-switch.
ALPHANUMERIC DIAL-PAD ENTRIES
1
Q – 11
Z – 12
. – 13
1 – 10
2
A - 21
B - 22
C - 23
2 - 20
3
D - 31
E - 32
F - 33
3 - 30
4
G – 41
H - 42
I - 43
4 - 40
5
J - 51
K - 52
L - 53
5 - 50
6
M - 61
N - 62
O - 63
6 - 60
7
P - 71
R - 72
S - 73
Q - 7*
7 - 70
8
T - 81
U - 82
V - 83
8 - 80
9
W - 91
X - 92
Y - 93
Z - 9#
9 - 90
*
Blank - *1
: - *2
, - *3
0
0-00
#
#
Conditions
1. Accessing an empty Speed Dial bin will return error tone.
2. A Speed Dial number uses a specific Line/or Line from a Group assigned in the
Speed Dial bin. If the assigned line is busy, a line from the same group will be
selected. If all lines in the group are busy, the user may queue for the next
available line.
3. All Speed Dial numbers are stored in memory protected from power loss.
4. For iPECS IP and LDP phones, a call placed with Speed Dial will appear under the
Flex button assigned for the Line, Line Group, or the general Line appearance
Loop button, as appropriate for the station Flex button configuration.
5. You may pre-select a Line for a Speed Dial number, overriding the Line
assignment in the Speed Dial bin.
6. A name can be entered for a Speed Dial number to permit access from the Dial-
by-Name directory.
7. If a Speed Dial number contains a “Dial Tone Detect” command(Flash as the first
entry) and dial tone detect is enabled for the Line, the system must detect dial tone
before dialing the Speed Dial number.
Programming
SYSTEM DATA
System Attributes CO Dial Tone Detect