iPECS UCP - Page 82

iPECS UCP
Feature Description and Operation Manual Issue 1.3
70
required),
− The Absent Supervisor timer,
− The No answer timer,
− The busy/no-answer Retry count,
− The Interval time: Each member is called in turn at expiration of the interval
timer.
4. Set the Member Attributes by entering:
− Index number
− Type: Station, CO Line, CO Group, Loop or Transit-out code (access loop
for networking call).
− CO value: the supervisor can select a specific CO line or CO group for
calling external members.
− Dial number: The station or external party number.
5. Press the Save button to store the Conference Group configuration.
1. Press [PGM] + “552”.
To activate conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
1. Press [PGM] + “553”.
To deactivate conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
1. Dial “Room Type Conf Group Join (5*0)” code.
To join system conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
Operation
IPECS phone & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “55” + [HOLD/SAVE]
To assign a {GRP MONITOR} button
1. Lift the handset.
To initiate a Conference Group call
2. Dial “68”xxx, the Conference Group code and group number (xxx).
3. Enter the Conference group password, if assigned, members receive the
Conference Group call.
1. Answer the ringing call and receive recorded announcement, if assigned and
recorded.
To enter a Conference Group call
2. Dial “1” to enter the conference or hang-up to reject the conference. For iPECS