iPECS UCP - Page 83

iPECS UCP
Feature Description and Operation Manual Issue 1.3
71
UCS clients, use Accept or Deny when notified of the conference.
1. Press the {GRP MONITOR} button, the state of the first member is displayed.
To monitor conference member status or delete members while in the conference
2. Press [VOL UP]/{VOL DOWN] button to display the state of other members.
3. Press the [DND] button to delete a participant from the conference.
1. Press the [TRANS/PGM] button.
To monitor the Group member conference status while Not in the conference
2. Dial “55”, the Monitor Conference Group code.
3. Press [VOL UP]/[VOL DOWN]button to display the state of other members.
1. Press the [HOLD/SAVE] button to place the conference on hold.
To add a non-member to the Group
2. Call the desired party.
3. Press the [CONF] button.
Conditions
1. The conditions associated with Multi-Party Voice Conference apply.
2. Members using the UCS client Soft phone may view the state of other members in
the conference.
3. A maximum of 100 Station Conference Groups can be created by any system user
and 160 System Conference Groups can be created in the iPECS UCP system.
4. The user must have access to the Station Web Admin with the proper password
(Authentication code).
5. If there are insufficient Conference channels available when initiating the
conference group call, the initiator receives error tone.
6. Two-way record can be used to record the Conference Group call.
7. An MCIM is required to support 32 party conferences. With the MCIU, the number
of parties in the conference cannot exceed the number of MCIU channels (6 to 18).
Refer to the iPECS UCP Hardware Description and Installation Manual for MCIU
capacities.
Programming
Related Features
 Multi-Party Voice Conference
 Conference Room
 System Admin Programming
Hardware