iPECS UCP - Page 85

iPECS UCP
Feature Description and Operation Manual Issue 1.3
73
password protected so that only parties that enter the password are allowed to join the Room.
As parties enter the Conference Room, a tone is provided notifying members that a party has
entered the conference.
Up to nine (9) Conference Rooms can be set-up and up to 32 parties with the g.711 or g.729
codec, or 24 parties with the g.722 or g.723 codec can be join a Conference Room.
Conference Rooms employ channels from an MCIM (Multi-party Conference Interface
Module) or the MCIU built-in the iPECS UCP100 and UCP600.
A system Attendant can view the list of participants in an active Conference Room and close
any Conference Room.
Operation
Attendant Phone
1. Press the [TRANS/PGM] button.
To view Room participant list
2. Dial “054”.
3. Dial Room number (“1”~”9”).
1. Press the [TRANS/PGM] button.
To delete a Conference Room
2. Dial “055”.
3. Dial Room number (“1”~”9”).
iPECS IP & LDP Phones
1. Press the [TRANS/PGM] button.
To open a Conference Room
2. Dial “53” to create a Conference Room.
3. Dial the desired Conference Room number (“1”~”9”).
4. If desired, enter a password (exactly 5 digits) for the Conference Room.
5. Press [HOLD/SAVE]button to open the Room.
1. Lift the handset or press the [SPEAKER] button.
To join a Conference Room
2. Dial “59”, the Conference Room entry code.
3. Dial the Conference Room Number.
4. Dial the Conference Room password, if required.
1. Press the [TRANS/PGM] button.
To close a Conference Room
2. Dial “54”, the close Conference Room code.
3. Dial the Conference Room number (1~9)
4. Dial the Conference Room password.
5. Press [HOLD/SAVE] to delete the Conference Room.
1. Press the [TRANS/PGM] button.
To transfer an active call to a Conference Room
2. Dial “59”, the Conference Room entry code.