iPECS UCP - Page 86

iPECS UCP
Feature Description and Operation Manual Issue 1.3
74
3. Dial the Conference Room Number.
4. Dial the Conference Room password.
5. Hang-up to complete the transfer.
SLT
1. Lift the handset.
To open a Conference Room
2. Dial “561”, SLT Programming code.
3. Dial “53”, the Create Conference Room code.
4. Dial the desired Conference Room number (“1”~”9”).
5. Dial the Conference Room password.
6. Momentarily press the hook-switch.
1. Lift the handset.
To join a Conference Room
2. Dial “59”, the Conference Room entry code.
3. Dial the Conference Room Number.
4. Dial the Conference Room password.
1. Lift the handset.
To close a Conference Room
2. Dial “561”, SLT Programming code.
3. Dial “54”, the close Conference Room code.
4. Dial the Conference Room number (“1”~”9”).
5. Dial the Conference Room password.
6. Momentarily press the hook-switch, receive confirmation tone.
Conditions
1. Once established, a Conference Room will remain opened until the Room is
closed.
2. iPECS UCS Client, DECT, etc. may also create, delete and join a Conference
Room. For operation, refer to the soft phone User Guide.
3. An MCIM is required to support 32 party conferences. With the MCIU, the number
of parties in the conference cannot exceed the number of MCIU channels (6 to 18).
Refer to the iPECS UCP Hardware Description and Installation Manual for MCIU
capacities. Note the capacity of the MCIU is reduced by approximately 1/3 when
transcoding of complex Codecs is needed.
Programming
Related Features
 Multi-Party Conference
 Automatic Speaker Select
 Hold Recall
Hardware