Keysight x-series Programmer's Reference

3 VMA Mode
3.7 Power Stat CCDF Measurement
Delta Marker (Reset Delta)
Pressing this button has exactly the same effect as pressing Delta in "Marker Mode"
on page 1137. The selected marker becomes a Delta marker. If the selected marker
is already a Delta marker, the reference marker is moved to the current position of
the selected marker, thus resetting the Delta to zero.
Marker Settings Diagram
Lets you configure the Marker system using a visual utility.
All Markers Off
Turns off all markers.
Remote
Command
:CALCulate:PSTatistic:MARKer:AOFF
Example
:CALC:PST:MARK:AOFF
Couple Markers
When this function is ON, moving any marker causes an equal X-Axis movement of
every other marker that is not Off. By “equal X-Axis movement” we mean that we
preserve the difference between each marker’s X-Axis value (in the fundamental x-
axis units of the trace that marker is on), and the X-Axis value of the marker being
moved (in the same fundamental x-axis units).
This may result in markers going off screen.
Remote
Command
:CALCulate:PSTatistic:MARKer:COUPle[:STATe] ON | OFF | 1 | 0
:CALCulate:PSTatistic:MARKer:COUPle[:STATe]?
Example
:CALC:PST:MARK:COUP ON
:CALC:PST:MARK:COUP?
Preset
OFF
Presets on Mode Preset and All Markers Off
State Saved Saved in instrument state
3.7.7.3 Properties
The controls on this tab are used to set certain properties of the selected marker.
Vector Modulation Analyzer Mode User's &Programmer's Reference 1138

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)