3 VMA Mode
3.3 Monitor Spectrum Measurement
Preset 1001 unless noted below
2001: 5GNR
State Saved Saved in instrument state
Min 1
Max 20001
Annotation On second line of annotations, in lower right corner in parenthesis behind the sweep annotation
Auto Sweep Points
When Auto Sweep Points is ON, the instrument determines the points using the
following calculation formula:
# points = ceil(Span / (Rbw * 1e3)) * 1000 + 1
Where ceil(x) returns the smallest possible integer value that is greater than or equal
to x.
Remote Command
[:SENSe]:MONitor:SWEep:POINts:AUTO[:STATe] OFF | ON | 0 | 1
[:SENSe]:MONitor:SWEep:POINts:AUTO[:STATe]?
Example
:MON:SWE:POIN:AUTO 0
:MON:SWE:POIN:AUTO?
Dependencies This parameter is available only in the 5GNR mode
Preset
ON
State Saved Yes
Range
OFF|ON
3.3.10 Trace
Lets you control the acquisition, display, storage, detection, and manipulation of
trace data for the available traces.
The "Trace Control" on page 1736 tab in this menu contains radio-button selections
for the trace type (Clear/Write, Trace Average, Max Hold, Min Hold) and View/Blank
setting for the selected trace.
3.3.10.1 Select Trace
Specifies the selected trace, which is the trace that will be affected when you
change trace settings.
659 Vector Modulation Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
