4 System
4.8 Security
4.8 Security
Accesses capabilities for operating the instrument in a security-controlled
environment.
The Security page of the System menu has two controls: USB Read/Write and
Restore Security Defaults.
Dependencies Not available in UXM
4.8.1 USB Write Protect
The Windows operating system can be configured to disable write access to the
USB ports for users who are in a secure environment where transferring data from
the instrument is prohibited. The USB Write Protect control is a convenient way for
you to disable write access to USB.
NOTE
This control is only available to users with Administrator privileges.
Remote Command
:SYSTem:SECurity:USB:WPRotect[:ENABle] ON | OFF | 0 | 1
:SYSTem:SECurity:USB:WPRotect[:ENABle]?
Example Set USB ports to Read-only:
:SYST:SEC:USB:WPR ON
Set USB ports to Read-Write:
:SYST:SEC:USB:WPR OFF
Notes When the USB ports are in Read-only mode, then no data can be stored to USB, including the internal
USB memory used for a back-up location for the calibration data
Dependencies Grayed-out unless the current user has Administrator privileges
Preset Unaffected by Preset or any "Restore Defaults" on page 1890. A Keysight Recovery sets the USB to
write protect OFF
State Saved No
Range Read-Write | Read only
4.8.2 Restore Security Defaults
Sets USB Read/Write to Enable.
NOTE
This control is only available to users with Administrator privileges.
1981 Vector Modulation Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
