Keysight x-series Programmer's Reference

6 Input/Output
6.5 Corrections
Apply Corrections affects both normal Corrections and Complex Corrections.
Normal Corrections are turned On and Off using the Correction switch under Select
Correction:
Complex Corrections are turned On and Off using the checkboxes in the Complex
Corrections dialog:
See "Correction On/Off" on page 2209) and "Complex Corrections" on page 2220.
Remote
Command
[:SENSe]:CORRection:CSET:ALL[:STATe] ON | OFF | 1 | 0
[:SENSe]:CORRection:CSET:ALL[:STATe]?
Example
:SENS:CORR:CSET:ALL OFF
This command makes sure that no amplitude corrections are applied, regardless of their individual
on/off settings
Couplings Whenever you turn on any Correction or Complex Correction, Apply Corrections is automatically set to
ON
Preset Not affected by Preset. Set to OFF by Restore Input/Output Defaults
State Saved Saved in instrument state
Annunciation When ON, ‘CORREC’ appears in the Meas Bar as long as at least one of the individual corrections is
enabled
6.5.9 Delete All Corrections
Erases all correction values for all Amplitude Correction sets and Complex
Corrections.
2227 Vector Modulation Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)