Keysight x-series Programmer's Reference

3 VMA Mode
3.1 Digital Demod Measurement
Marker Window
Assigns the specified marker to the designated trace.
Remote Command
:CALCulate:DDEMod:MARKer[1]|2|…|12:WINDow <int>
:CALCulate:DDEMod:MARKer[1]|2|…|12:WINDow?
Example
:CALC:DDEM:MARK:WIND 2
Sets the first marker’s trace to window 2
:CALC:DDEM:MARK:WIND?
Query the first marker’s trace
Notes Assigns the specified marker to the designated window
Preset 1
State Saved Yes
Min/Max 1 / 6
Marker Settings Diagram
Enables you to configure the Marker system using a visual utility. This is the same as
"Marker Settings Diagram" on page 292 on the Settings tab.
3.1.8.5 Marker Function
The controls on this tab enable you to control the Marker Functions of the
instrument. Marker Functions perform post-processing operations on marker data.
Marker X
Set the X Axis value of the selected marker in the current X Axis Scale unit. This is
the same as "Marker X" on page 289 on the Settings tab.
Band Function
Enables you to set the marker control function type to one of the following:
NOISe
Marker Noise
BPOWer
Band Power
BDENsity
Band Density
OFF
Marker Function Off
297 Vector Modulation Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)