Keysight x-series Programmer's Reference

9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Bit Condition Operation
0 Align RF
skipped
During an alignment, the calibration of the RF section (frontend) of the
instrument was not performed. This can be caused by an interfering
user signal present at the RF Input
See "Align Now" on page 1900, "Align Now All" on page 1902
Filter Registers
–
"Questionable Calibration Skipped Condition" on page 2615
–
"Questionable Calibration Skipped Enable" on page 2616
–
"Questionable Calibration Skipped Event Query" on page 2616
–
"Questionable Calibration Skipped Negative Transition" on page 2616
–
"Questionable Calibration Skipped Positive Transition" on page 2617
Questionable Calibration Skipped Condition
Returns the decimal value of the sum of the bits in the Questionable Calibration
Skipped Condition register.
NOTE
The data in this register is continuously updated and reflects the current
conditions.
Remote
Command
:STATus:QUEStionable:CALibration:SKIPped:CONDition?
Example
:STAT:QUES:CAL:SKIP:COND?
Preset 0
Status Bits/OPC
dependencies
Sequential command
2615 Vector Modulation Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)