Keysight x-series Programmer's Reference

5 Preset
5.5 Full Mode Preset
5.5 Full Mode Preset
Same as performing "Mode Preset" on page 1996, "Restore Mode Defaults" on page
1998, and "Input/Output Preset" on page 1999. Essentially a factory preset of the
current Mode.
When Full Mode Preset is selected, a message appears saying:
This will reset all of the current Mode’s variables and all of the Input/Output
variables to their default state, including Input and Output selection and
settings, Amplitude Correction, Frequency Reference and RF Source settings.
It will not affect Alignment data or settings.
This action cannot be undone. Do you want to proceed?
The message provides OK and Cancel buttons, to let you confirm or cancel the
operation.
Remote Command
:SYSTem:PRESet:FULL
Example
:SYST:PRES:FULL
Status Bits/OPC depend-
encies
Clears all pending OPC bits. The Status Byte is set to 0
Vector Modulation Analyzer Mode User's &Programmer's Reference 2000

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)