3 VMA Mode
3.1 Digital Demod Measurement
Next Higher Amplitude
Moves the marker to the peak next higher in Y value than the peak it is currently on.
If the format is complex (vector or constellation) then the marker moves to the
closest point that has a higher magnitude than the marker's current position. If this
function is invoked via SCPI on a marker that is off, the result is the same as if you
sent a Peak Search command.
Remote Command
:CALCulate:DDEMod:MARKer[1]|2|…|12:MAXimum:PREVious
Example
:CALC:DDEM:MARK2:MAX:PREV
Next Pk Right
Moves the selected marker to the nearest peak right of the current marker that
meets all enabled peak criteria. If there is no valid peak to the right of the current
marker position, a “No peak found” message is generated and the marker is not
moved.
If the selected marker was off, then it is turned on as a Normal marker and a peak
search is performed.
Remote Command
:CALCulate:DDEMod:MARKer[1]|2|…|12:MAXimum:RIGHt
Example
:CALC:DDEM:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Left
Moves the selected marker to the nearest peak left of the current marker that meets
all enabled peak criteria. If there is no valid peak to the left of the current marker
position, a “No peak found” message is generated and the marker is not moved.
If the selected marker was off, then it is turned on as a Normal marker and a peak
search is performed.
Remote Command
:CALCulate:DDEMod:MARKer[1]|2|…|12:MAXimum:LEFT
Example
:CALC:DDEM:MARK2:MAX:LEFT
State Saved Not part of saved state
Vector Modulation Analyzer Mode User's &Programmer's Reference 294
To Next Page
Loading...
Need help?
General
