Keysight x-series Programmer's Reference

3 VMA Mode
3.7 Power Stat CCDF Measurement
State Saved Saved in instrument state
Min/Max 1000/2000000000
Meas Cycles
Set the number of measurement cycles to calculate power statistic data. This
number is coupled to "Counts" on page 1140, by:
Meas Cycles = Counts / (Sampling Frequency * Meas Interval)
When the Counts value cannot be divided by (Sampling Frequency * "Meas Interval"
on page 1141), this value is displayed as a decimal fraction.
Remote
Command
[:SENSe]:PSTatistic:SWEep:CYCLes <real>
[:SENSe]:PSTatistic:SWEep:CYCLes?
Example
:PST:SWE:CYCL 1001
:PST:SWE:CYCL?
Preset Depends on the sampling frequency
Min 0.001
Max Depends on the sampling frequency
Meas Interval
Sets the number of data points to be used as the measurement interval. This value
couples to "Counts" on page 1140, as:
Meas Interval = Counts / ("Meas Cycles" on page 1141 * Sampling Frequency)
Remote
Command
[:SENSe]:PSTatistic:SWEep:TIME <time>
[:SENSe]:PSTatistic:SWEep:TIME?
Example
:PST:SWE:TIME 2 ms
:PST:SWE:TIME?
Preset 1.0 ms !unless noted below
LTEATDD, 5G NR: 500 us
Min/Max 50.0 us/10.0 ms !unless noted below
LTEATDD, 5G NR: 1 us/10.0 ms
Meas Setup Summary Table
Lets you view and access many of the parameters in the Meas Setup menus on one
screen.
1141 Vector Modulation Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)