Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 258
Any: Any frame can match this ACE.
Ethernet Type: Only Ethernet Type frames can match this ACE. The IEEE 802.3 describes the value of
Length/Type Field specifications to be greater than or equal to 1536 decimal (equal to 0600 hexadecimal)
and the value should not be equal to 0x800(IPv4), 0x806(ARP) or 0x86DD(IPv6).
ARP: Only ARP frames can match this ACE. Notice the ARP frames won't match the ACE with ethernet
type.
IPv4: Only IPv4 frames can match this ACE. Notice the IPv4 frames won't match the ACE with ethernet
type.
IPv6: Only IPv6 frames can match this ACE. Notice the IPv6 frames won't match the ACE with Ethernet
type.
Action: Specify the action to take with a frame that hits this ACE.
Permit: The frame that hits this ACE is granted permission for the ACE operation.
Deny: The frame that hits this ACE is dropped.
Filter: Frames matching the ACE are filtered.
Filter Port: Select the filter port for action.
All: The action applies to all port.
Port n: The action applies to this port number, where n is the number of the switch port.
Rate Limiter: Specify the rate limiter in number of base units. The allowed range is 1 - 16. Disabled indicates that
the rate limiter operation is disabled.
Port Redirect: Frames that hit the ACE are redirected to the port number specified here. The rate limiter will
affect these ports. The allowed range is the same as the switch port number range. Disabled indicates that the
port redirect operation is disabled and the specific port number of 'Port Redirect' can't be set when action is
permitted.
Mirror: Specify the mirror operation of this port. Frames matching the ACE are mirrored to the destination mirror
port. The rate limiter will not affect frames on the mirror port. The allowed values are:
Enabled: Frames received on the port are mirrored.
Disabled: Frames received on the port are not mirrored. The default value is "Disabled".
Logging: Specify the logging operation of the ACE. Notice that the logging message doesn't include the 4 bytes
CRC information. The allowed values are:
Enabled: Frames matching the ACE are stored in the System Log.
Disabled: Frames matching the ACE are not logged.
Note: The logging feature only works when the packet length is less than 1518 (without VLAN tags) and the
System Log memory size and logging rate is limited.
Shutdown: Specify the port shut down operation of the ACE. The allowed values are:
Enabled: If a frame matches the ACE, the ingress port will be disabled.
Disabled: Port shut down is disabled for the ACE.
Note: The shutdown feature only works when the packet length is less than 1518 (without VLAN tags).
Counter: The counter indicates the number of times the ACE was hit by a frame.
To Next Page
Loading...
Need help?
General
