Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 313
Auto-refresh: Click to on to refresh the page automatically every 3 seconds. Note: Checking Auto-refresh to on
does not refresh the value of the "Command" selection.
Apply: Click to save changes.
Cancel: Click to undo any changes made locally and revert to previously saved values.
Reset : Click to go back to the Web page from which this page was invoked.
Counter types for Port0 and Port1:
Received erroneous R-APS PDUs
Received R-APS PDUs with our own node ID
Received R-APS PDUs during guard timer
Received R-APS PDUs causing FOP-PM
Received NR R-APS PDUs
Received NR, RB R-APS PDUs
Received SF R-APS PDUs
Received FS R-APS PDUs
Received MS R-APS PDUs
Received Event R-APS PDUs
Transmitted NR R-APS PDUs
Transmitted NR, RB R-APS PDUs
Transmitted SF R-APS PDUs
Transmitted FS R-APS PDUs
Transmitted MS R-APS PDUs
Transmitted Event R-APS PDUs
Number of local signal fails
Number of FDB flushes
Messages:
Ring Id must be an integer value between 1 and 239
JSON RPC Error. (Invalid instance number specified for connected ring)
Port0 MEPID must be an integer value between 1 and 8191
JSON RPC Error. (Invalid hold-off-time. Valid range is [0; 10000] milliseconds in steps of 100 milliseconds)
JSON RPC Error. (The control VLAN cannot be part of the protected VLANs)
Port0 Domain cannot be empty
Port0 Domain must not contain leading digit
Port1 Service cannot be empty
Port1 Service must not contain leading digit
Guard Time must be an integer value between 0 and 2000
WTR must be an integer value between 0 and 720
MAC address must be 12 characters long
HoldOff must be an integer value between 0 and 10000
JSON RPC Error. (Invalid params)
JSON RPC Error. (ERPS instance is not active)
JSON RPC Error. (ERPS instance is not valid)
To Next Page
Loading...
Need help?
General
