Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 353
OSPF Router Mode: Enable or Disable the OSPF router mode.
Router ID: Set the OSPF Router ID in IPv4 address format (A.B.C.D). When the router's OSPF Router ID is
changed, if there is one or more fully adjacent neighbors in current OSPF area, the new router ID will take effect
after restart OSPF process. Note that the router ID should be unique in the Autonomous System and the value
'0.0.0.0' is invalid since it is reserved for the default algorithm.
Auto: The default algorithm will choose the largest IP address assigned to the router.
Specific: User specified router ID. The allowed range is 0.0.0.1 - 255.255.255.254.
Default Passive Mode: Configure all interfaces as passive-interface by default. When an interface is configured
as a passive-interface, sending OSPF routing updates is suppressed, so the interface does not establish
adjacencies (No OSPF Hellos). The subnet of all interfaces (both passive and active) is advertised by the OSPF
router.
Default Metric: User specified default metric value for the OSPF routing protocol. The field is significant only
when the arugment 'IsSpecificDefMetric' is TRUE.
Auto: The default metric is calculated automatically based on the routing protocols.
Specific: Specify the metric to be used. The allowed range is 0 to 16777214.
Static Redistribute Metric Type: The OSPF redistributed metric type for the static routes.
None: The static routes are not redistributed.
External Type 1: External Type 1 of the static routes.
External Type 2: External Type 2 of the static routes.
Static Redistribute Metric Value: User specified metric value for the static routes. The field is significant only
when the argument 'StaticRedistIsSpecificMetric' is TRUE. The allowed range is 0 to 16777214.
Auto: The redistributed metric is the same as the original metric value.
Specific: User specified metric for the static routes.
Connected Redistribute Metric Type: The OSPF redistributed metric type for the connected interfaces.
None: The connected interfaces are not redistributed.
External Type 1: External Type 1 of the connected interfaces routes.
External Type 2: External Type 2 of the connected interfaces routes.
Connected Redistribute Metric Value: User specified metric value for the connected interfaces. The field is
significant only when the argument 'ConnectedRedistIsSpecificMetric' is TRUE. The allowed range is 0 to
16777214.
Auto: The redistributed metric is the same as the original metric value.
Specific: User specified metric for the connected routes.
RIP Redistribute Metric Type: The OSPF redistributed metric type for the RIP routes. The field is significant only
when the RIP protocol is supported on the device.
None: The RIP routes are not redistributed.
External Type 1: External Type 1 of the RIP routes.
External Type 2: External Type 2 of the RIP routes.
RIP Redistribute Metric Value: User specified metric value for the RIP routes. The field is significant only when
the RIP protocol is supported on the device and argument 'RipRedistIsSpecificMetric' is TRUE. The allowed range
is 0 to 16777214.
Auto: The redistributed metric is the same as the original metric value.
Specific: User specified metric for the RIP routes.
Stub router during startup period: Configures OSPF to advertise a maximum metric during startup for a
configured period of time.

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English