MacDon M205 - Page 119

214603 99 Revision A
1009974
C###
X###
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.88: M205 CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
1009995
DWA INSTALLED?
NO/YES
C###
X###
B
A
Figure 3.89: M205 DWA Controls
4. Press SELECT (B) until DWA INSTALLED? is displayed
on the upper line.
• NO/YES is displayed on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
1009996
SWAP DWA CONTROLS?
NO/YES
C###
X###
B
A
Figure 3.90: M205 DWA Controls
6. SWAP DWA CONTROLS? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
NOTE:
This step swaps the DWA controls from the console
switch to the ground speed lever (GSL) reel fore-aft
buttons.
OPERATOR’S STATION